Re: LYNX-DEV Compilation error

[Francisco A. Tomei Torres]

Thank you for your suggestions.

None of them worked.

The compilation stops before LYMainLoop.o is created.

At 03:24 PM 9/10/97 -0500, Klaus Weide wrote:
>On Wed, 10 Sep 1997, T.E.Dickey wrote:
>
>> > I tried to compile your latest development post on a NeXTstation running
>> > NeXTstep/OpenStep 4.0
>> 
>> >  -DXMOSAIC_HACK  -c ./LYMain.c
>> > cc -DHAVE_CONFIG_H  -I.. -I../WWW/Library/Implementation   -O2 -DNEXT=
>> >  -DXMOSAIC_HACK  -c ./LYMainLoop.c
>> > cc: Internal compiler error: program cc1obj got fatal signal 11
>> > make[1]: *** [LYMainLoop.o] Error 1
>> > make[1]: Leaving directory `/root/temp/lynx2-7-1/src'
>> > make: *** [all] Error 2
>
>> Try taking the optimization (-O2) out of the makefile.
>> (LYMainLoop.c is excessively large & probably should have been split up
>> long ago - but that's probably what's breaking this).
>
>ALso see whether it reproducible.  Just 'rm src/LYMainLoop.o' (in case
>it has been partially created) and run make again, maybe after running
>some other commands for a while.  It may not have anything to do with the
>Lynx source.
>
>See <URL:http://www.bitwizard.nl/sig11/> for "The SIG11 problem", although
>that is written for linux it may also apply to you.
>
>    Klaus
>
>
>
;
; To UNSUBSCRIBE:  Send a mail message to address@hidden
;                  with "unsubscribe lynx-dev" (without the
;                  quotation marks) on a line by itself.
;