[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [lwip-users] lwIP on a Microcontroller with two MACs
From: |
tsotb |
Subject: |
Re: [lwip-users] lwIP on a Microcontroller with two MACs |
Date: |
Sat, 4 May 2019 15:21:43 +0200 |
Hello,
was 1.) also a question?
I would not start a new design with a controller which is not recommended
for new designs.
Take a look at the NXP iMX1060 which is faster and quite new. You can get
examples with lwIP in there SDK from here:
https://mcuxpresso.nxp.com/en/select
Best Regards
-----Ursprüngliche Nachricht-----
Von: lwip-users <address@hidden> Im Auftrag von
sanjayks
Gesendet: Donnerstag, 2. Mai 2019 11:23
An: address@hidden
Betreff: [lwip-users] lwIP on a Microcontroller with two MACs
Hi All,
I am new to lwIP. I have a requirement in front of me. Please guide me
where to look for.
Requirement:
1. I need a card with two ethernet ports. ( Two PHY, two MACs and two IP
addresses). The hardware designer suggested Atmel SAM9X25 which has two
PHYs.
2. I do not see a port of lwIP for SAM9X25.
3. Where do I start from? Can I start with a lwIP port for any SAM series of
Atmel and add my own ethernet driver which can handle two MACs ?
4. Are there any specific things that need to be handled when I try to use
lwIP on a microcontroller with two PHYs.
Please suggest what to look for and where to look for. Shall do the
necessary hardwork myself :).
Regards,
Sanjay
--
Sent from: http://lwip.100.n7.nabble.com/lwip-users-f3.html
_______________________________________________
lwip-users mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/lwip-users