[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[lwip-users] Communication delays, if using lwIP in different network ar

From: Benjamin Schelte
Subject: [lwip-users] Communication delays, if using lwIP in different network areas
Date: Thu, 11 Nov 2010 17:59:32 +0100

Hi all,


today our testers found out a massive problem, when they were putting a device with lwIP 1.3.2 or 1.4.0.rc1 (they tested both) in a different network, than the host PC.

The PC is in the network 10.x.x.x (IP assignment via a DHCP server)

The device is in the network 192.x.x.x (IP assignment via a DHCP server)

The network routes are fine, otherwise some services would not work in our company J


Device config: lwIP 1.3.2 or 1.4.0.rc1, RTOS, netconn-API and sockets


Pinging a device is not a problem at all. The response is sent in <1ms most of the times.

The problem arises, if I send tcp data from the PC to the device to a specific port, which is kept open as a response channel by the device.

The ACK to the received packets is sent immediately from the device, as I can see in the dump of the router or in wireshark. So it seems that there is no problem with the router in between the networks.

Then the device takes a timeout of 1-2.5 seconds, before sending the response package (wireshark and router logs proof that the packet is sent after that time and not earlier).

In between the PC retransmits the last package of the data and then the device starts to send its response…


For me it seems like the stack in the device doesn’t know, where to send the data to until the next packet arrives. Is that possible somehow?


Usually we put both the device and the PC in the same network area i.e. 10.x.x.x. If we do so the communication is smooth and everything works fine.

The above described data exchange takes approximately 250ms at most.


Does anybody have a clou, what the problem could be?

Is there any setting in the options, that can have an influence on this behavior?



Furthermore (and maybe not related to the above problem) is the fact that sometimes the device sends packets (which I don’t know the content yet) to address, if we have to transfer quite a lot data from the PC to the device.

And this occurs only, if PC and device are not in the same network area.


Best regards,



reply via email to

[Prev in Thread] Current Thread [Next in Thread]