Samba is not available in the flash based file
system. Samba is quite large and does not fit in the allocated flash
space. You can run samba if you boot with the hard disk based file
system. You can boot this using the u-boot macro by running the following
command:
"run flashhdboot"
Joe D.
Hi,
I'm using Freescale MPC8349ITX
board,which is a NAS device.It uses samba service.I wanna know if the linux
system on the on-board flash already has samba service,so I only have to start
it,or I must re-compile the kernel using LTIB and add samba service into the
system?
Thank you!
sincerely
yours
|