[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Libcdio-devel] building libcdio from cvs
From: |
R. Bernstein |
Subject: |
[Libcdio-devel] building libcdio from cvs |
Date: |
Fri, 7 Mar 2008 21:34:38 -0500 |
The top of README.libcdio reads:
If you check out the source from CVS run
./autogen.sh then follow as below, except you don't need to run
./configure.
Robert William Fuller writes:
> I tried to build libcdio from CVS. Briefly, I did:
>
> cvs -z3 -d:pserver:address@hidden:/sources/libcdio co
> libcdio
> ./autogen.sh
>
> I get the following error:
>
> config.status: error: cannot find input file: Makefile.in
>
> Should I use the libcdio-0.79 and generate patches against that? Am I
> missing something obvious?
>
> Regards,
>
> Rob
>
>