[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
## Re: plotting transfer function in octave 5.2: How to fix error: set: "da

**From**: |
shall689 |

**Subject**: |
Re: plotting transfer function in octave 5.2: How to fix error: set: "dataaspectratio' must be finite |

**Date**: |
Fri, 7 Aug 2020 10:31:27 -0500 (CDT) |

Hello Torsten,
>* If you consider the complete control loop in discrete time (the system*
>* has to be discretized), then you do not need any transfer function for*
>* your hold device. Instead, it is considered in the calculation of the*
>* discrete time system representation. If, e.g., the used D/A has a zero-*
>* order hold, than the discretization method makes use of the fact that*
>* the input u is constant during a sampling interval.*
Yes, if I use the ZOH method when discretizing, the ZOH will be included.
What if there are two feedbacks, i.e a voltage and a current feedback (see
diagram below)? Should the ZOH be placed in both loops as shown in the
second diagram? My system is sampling all feedbacks at the same time, so
there is essentially only one delay; however, I think two zero order holds
would add two delays.
Stephen
<https://octave.1599824.n4.nabble.com/file/t372348/TwoLoopControlDiagram.jpg>
<https://octave.1599824.n4.nabble.com/file/t372348/TwoLoopControlDiagramWithZOH.jpg>
--
Sent from: https://octave.1599824.n4.nabble.com/Octave-General-f1599825.html

**Re: plotting transfer function in octave 5.2: How to fix error: set: "dataaspectratio' must be finite**, *Torsten Lilge*, `2020/08/01`
**Re: plotting transfer function in octave 5.2: How to fix error: set: "dataaspectratio' must be finite**, *shall689*, `2020/08/03`
**Re: plotting transfer function in octave 5.2: How to fix error: set: "dataaspectratio' must be finite**, *Doug Stewart*, `2020/08/03`
**Re: plotting transfer function in octave 5.2: How to fix error: set: "dataaspectratio' must be finite**, *Torsten Lilge*, `2020/08/03`
**Re: plotting transfer function in octave 5.2: How to fix error: set: "dataaspectratio' must be finite**,
*shall689* **<=**
**Re: plotting transfer function in octave 5.2: How to fix error: set: "dataaspectratio' must be finite**, *Sergei Steshenko*, `2020/08/07`
**Re: plotting transfer function in octave 5.2: How to fix error: set: "dataaspectratio' must be finite**, *Torsten Lilge*, `2020/08/08`
**Re: plotting transfer function in octave 5.2: How to fix error: set: "dataaspectratio' must be finite**, *shall689*, `2020/08/09`
**Re: plotting transfer function in octave 5.2: How to fix error: set: "dataaspectratio' must be finite**, *Torsten Lilge*, `2020/08/11`
**Re: plotting transfer function in octave 5.2: How to fix error: set: "dataaspectratio' must be finite**, *shall689*, `2020/08/11`