[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: SLATEC error: Chebyshev series too short for specified accuracy
From: |
Ben Abbott |
Subject: |
Re: SLATEC error: Chebyshev series too short for specified accuracy |
Date: |
Tue, 22 Feb 2011 08:12:39 -0500 |
On Feb 22, 2011, at 6:53 AM, Camillo wrote:
> Hello,
>
> I am working on a Mac build of Octave 3.4.0. It's almost complete: it passes
> 6908 tests, has 2 known failures, and 5 unexpected ones. All of these five
> are due to the same issue, an exception inside SLATEC: "Chebyshev series too
> short for specified accuracy". I don't know Fortran and I'm not sure how to
> best debug the issue. The compilers I am using are gcc and gfortran 4.2.1.
>
> Any ideas?
>
> Best regards,
> Camillo Lugaresi
I've not seen this error.
Where did you get your gfortran?
What dependencies did you install?
What was the result of running ./configure? (it gives a summary at the end)
Finally, please copy-n-paste the actual error.
Ben
- SLATEC error: Chebyshev series too short for specified accuracy, Camillo, 2011/02/22
- Re: SLATEC error: Chebyshev series too short for specified accuracy,
Ben Abbott <=
- Message not available
- Re: SLATEC error: Chebyshev series too short for specified accuracy, Ben Abbott, 2011/02/22
- Re: SLATEC error: Chebyshev series too short for specified accuracy, Camillo, 2011/02/23
- Re: SLATEC error: Chebyshev series too short for specified accuracy, bpabbott, 2011/02/23
- Re: SLATEC error: Chebyshev series too short for specified accuracy, Camillo, 2011/02/23
- Re: SLATEC error: Chebyshev series too short for specified accuracy, Ben Abbott, 2011/02/23