Re: Up-arrow on 2.1.73 without readline

[Tatsuro MATSUOKA]

Hello

Perhaps 2.1.73 is too old to discuss here.
Why do not you ask maintainers of your computer to upgrade gnuplot to 4.2.3 or 
later.
That is the best way.

Up-Arrow does not recall the most recent
> commands. Instead it displays [[^A

Perhaps the above is the terminal key binding issue but not of the readline. 


Regards

Tatsuro

--- spasmous <address@hidden> wrote:

> I have installed octave on an old Linux system that I cannot upgrade. I
> tried installing 3.03 but the gnuplot version was not recent enough so I
> went to 2.1.73. This version compiles but I need to specify the
> --disable-readline flag in ./configure. Once at the octave command line, a
> minor inconvenience is that Up-Arrow does not recall the most recent
> commands. Instead it displays [[^A. I was wondering if this is a readline
> issue? Is there a way to modify the key bindings in an Octave setup file?
> 
> Thanks for your help!
> > _______________________________________________
> Help-octave mailing list
> address@hidden
> https://www-old.cae.wisc.edu/mailman/listinfo/help-octave
> 


--------------------------------------
Power up the Internet with Yahoo! Toolbar.
http://pr.mail.yahoo.co.jp/toolbar/