[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: GRUB2 kernel/boot messages

From: Barry Jackson
Subject: Re: GRUB2 kernel/boot messages
Date: Thu, 02 Jun 2011 10:34:59 +0100
User-agent: Mozilla/5.0 (X11; U; Linux i686 (x86_64); en-UK; rv: Gecko/20110601 Lightning/1.0b2 Lanikai/3.1.11pre

On 01/06/11 18:59, Gus Zernial wrote:
I have Kubuntu Natty and GRUB2 1.99~rc1-13ubuntu and I can't figure out how to 
boot/kernel messages during boot. My /etc/default/grub is below, and I've tried 
GRUB_CMDLINE_LINUX_DEFAULT= to "splash" and "", and doing update-grub 
which I thought was the way, but no luck. Can someone tell me how to get my boot
messages back?             Thx, Gus

cat /etc/default/grub
# If you change this file, run 'update-grub' afterwards to update
# /boot/grub/grub.cfg.

GRUB_DISTRIBUTOR=`lsb_release -i -s 2>  /dev/null || echo Debian`

# Uncomment to enable BadRAM filtering, modify to suit your needs
# This works with Linux (no patch required) and with any kernel that obtains
# the memory map information from GRUB (GNU Mach, kernel of FreeBSD ...)

# Uncomment to disable graphical terminal (grub-pc only)

# The resolution used on graphical terminal
# note that you can use only modes which your graphic card supports via VBE
# you can see them in real GRUB with the command `vbeinfo'

# Uncomment if you don't want GRUB to pass "root=UUID=xxx" parameter to Linux

# Uncomment to disable generation of recovery mode menu entries

# Uncomment to get a beep at grub start
#GRUB_INIT_TUNE="480 440 1"


Help-grub mailing list

You could try GRUB_CMDLINE_LINUX_DEFAULT="verbose", however I don't know much about u/kubuntu.
This is really a question for your distro.
Grub merely passes verbatim any kernel parameters you set.

reply via email to

[Prev in Thread] Current Thread [Next in Thread]