[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

ubxtool configuration

From: Florian Kiera
Subject: ubxtool configuration
Date: Mon, 25 May 2020 16:50:43 +0200
User-agent: Mozilla/5.0 (X11; Linux x86_64; rv:68.0) Gecko/20100101 Thunderbird/68.8.1

Heyo all,

I want to configure the rover and base M8P with ubxtool now. On my rover's computer I run "gpsd -n /dev/ttyACM0 -G ntrip://root:root@ -N" to receive correction data (RTCM3).
How can I address /dev/ttyACM0 with ubxtool (to configure it)?
Just using "ubxtool -p CONFIG" will end up with "{"class":"ERROR","message":"No path specified in DEVICE, but multiple devices are attached."}"
Using "ubxtool -f /dev/ttyACM0 -p RESET" will end up with:

ubxtool: failed to open serial port "/dev/ttyACM0"
ubxtool: Your computer has the serial ports:
    /dev/ttyS0: ttyS0
    /dev/ttyACM0: u-blox GNSS receiver

Because its used already probably... Still there must be a way to achieve it which I do not see. Is just ignoring the "ubxtool -p CONFIG" error the solution? Not really beautiful is it?

Regards Florian

reply via email to

[Prev in Thread] Current Thread [Next in Thread]