[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: gnokii and Nokia Card Phone RPM-3 GSM900/1800

From: Pawel Kot
Subject: Re: gnokii and Nokia Card Phone RPM-3 GSM900/1800
Date: Wed, 1 Jul 2009 10:15:35 +0200


On Wed, Jul 1, 2009 at 09:48, Vieri<address@hidden> wrote:
> I'm trying to send a basic text SMS with gnokii connected via serial cable to 
> a Nokia Card Phone RPM-3 GSM900/1800.

Apparently there is some problem with timing. Gnokii reads the answer
for the previous AT command.

> From previous manual research in a Windows environment (hyperterminal), it 
> was determined that the correct sequence of commands to send an SMS is:
> AT+CMGS="<destination_number>"
> <ctrl-Z/ESC>

This is TEXT mode SMS. gnokii supports just PDU mode.

> Gnokii is failing as shown in the log files I'm attaching.
> I've also tried the -C 0,1,2,3 option with the gnokii --sendsms command line 
> but I'm still not able to send a message.
> Note: I am not using smsd, just "gnokii --sendsms ...".
> Any ideas?
> How can I customize gnokii's AT command sequence?

You can implement TEXT mode in AT driver but I don't think it will
change anything. It's hard to say where the problem is. Probably
putting some delay after ATZ may help.

take care,
Pawel Kot

reply via email to

[Prev in Thread] Current Thread [Next in Thread]