Nokia 6103 with CA-42

[kirk]

I'm trying to connect with my Nokia 6103 (like the 6101) using
gnokii-0.6.13 and am getting connection errors. The CA-42 cable is
detected correctly in SuSE 10.1:

   usb 1-1: new full speed USB device using uhci_hcd and address 5
   usb 1-1: new device found, idVendor=10b5, idProduct=ac70
   usb 1-1: new device strings: Mfr=1, Product=2, SerialNumber=0
   usb 1-1: Product: USB-Serial Controller C
   usb 1-1: Manufacturer: Prolific Technology Inc.
   usb 1-1: configuration #1 chosen from 1 choice
   pl2303 1-1:1.0: cp2101 converter detected
   usb 1-1: reset full speed USB device using uhci_hcd and address 5
   usb 1-1: cp2101 converter now attached to ttyUSB0

This is the output that is returned from the command 'gnokii --getdatetime':

   GNOKII Version 0.6.13
   LOG: debug mask is 0x1
   phone instance config:
   model: 6101
   port_device: /dev/ttyUSB0
   connection_type: 0
   init_length: 0
   serial_baudrate: 19200
   serial_write_usleep: -1
   hardware_handshake: 0
   require_dcd: 0
   smsc_timeout: 100
   connect_script:
   disconnect_script:
   rfcomm_cn: 1
   sm_retry: off
   Connecting
   Serial device: opening device /dev/ttyUSB0
   Gnokii serial_open: open: Protocol error
   Couldn't open FBUS device: Protocol error
   Error in link initialisation: 1
   Serial device: opening device /dev/ttyUSB0
   Gnokii serial_open: open: Protocol error
   Couldn't open FBUS device: Protocol error
   Error in link initialisation: 1
   Serial device: opening device /dev/ttyUSB0
   Gnokii serial_open: open: Protocol error
   Couldn't open FBUS device: Protocol error
   Error in link initialisation: 1
   Telephone interface init failed: Command failed.
   Quitting.
   Serial device: closing device

The connection attempt registered the following comments in system log
files:

   cp2101 ttyUSB0: cp2101_set_config - Unable to send request,
request=0x0 size=2 result=-32
   cp2101 ttyUSB0: cp2101_open - Unable to enable UART

Any help would be greatly appreciated. Thanks, --Kirk