nokia 6100 over usb cable

[Jan Stifter]

Hello,
i am trying to use my 6100 with gnokii.

Data: gnokii 0.5.5, linux kernel 2.4.21, usb cable (modprobe pl2303), port = 
/dev/ttyUSB0

I tried minicom and I can connect to the phone with AT commands and could use 
ATD to dial a phone number, so the connection is not the problem.


Having compiled gnokii with --enable-debug gives me the following:

suba:~ # gnokii --monitor
GNOKII Version 0.5.5
Opened configuration file /root/.gnokiirc
Added new section global
Adding key/value port//dev/ttyUSB0
Adding key/value model/6100
Adding key/value initlength/default
Adding key/value connection/serial
Adding key/value bindir//usr/sbin/
Adding key/value use_locking/no
Added new section connect_script
Adding key/value TELEPHONE/12345678
Added new section disconnect_script
phone instance config:
model: 6100
port_device: /dev/ttyUSB0
connection_type: 0
init_length: 0
serial_baudrate: 19200
serial_write_usleep: -1
hardware_handshake: 0
require_dcd: 0
smsc_timeout: 100
connect_script:
disconnect_script:
Connecting
Serial device: opening device /dev/ttyUSB0
Serial device: setting speed to 115200
Serial device: setting RTS to low and DTR to low
Getting model...
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
SM_Block Retry - 0
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
SM_Block Retry - 1
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
SM_Block Retry - 0
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
SM_Block Retry - 1
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
SM_Block Retry - 0
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
SM_Block Retry - 1
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
Serial device: opening device /dev/ttyUSB0
Serial device: setting speed to 115200
Serial device: setting RTS to low and DTR to high
Getting model...
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
Serial write: transmitter busy, waiting
Serial write: transmitter ready
Serial write: transmitter busy, waiting
Serial write: transmitter ready
SM_Block Retry - 0
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
SM_Block Retry - 1
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
<CTRL/c>
Segmentation fault
suba:~ #


What can I do? Is something wrong with my configuration? Can I connect to the 
phone by using AT commands (but still reading the addressbook)?

Many thanks in advance
Jan Stifter