Re: gnokii Nokia 7210 and irda

[Pawel Kot]

On Fri, 26 Dec 2003, getting_out wrote:

> Hello people.
> I'm trying to connect a nokia 7210 via irda and gnokii on a debian
> stable 3.0 (aka woody).
> When I start xgnokii, it remain in connection mode even if I put the
> phone infront of the irda or not.

What about cli gnokii?

> This are some config:
>
> $ cat /etc/irda.conf
> #irda.conf Version: 1.0
> IRDADEV=/dev/ttyS1
> #DONGLE= # specify dongle type
> DISCOVERY=-s
> ENABLE=yes # if you do not need to start irattach, set "no"
>
> $ uname -a
> Linux rippingland.bagginslab.it 2.4.23.20031221 #1 Sun Dec 21 14:46:28
> CET 2003 i686 unknown
>
> $ dpkg -l | grep -i irda
> ii  irda-common    0.9.14-17      IrDA management utilities
> ii  irda-tools     0.9.14-17      IrDA handling tools
>
> $ cat .gnokiirc
> [global]
> port = /dev/ttyS1
port = /dev/ircomm0

> model = 6610
> initlength = default
> connection = infrared
connection = irda

> bindir = /usr/local/sbin/
>
> also tried the connection = irda
>
> I've put the 6610 model 'cause of reading the archive I saw that it's
> almost the same of 7210.
[...]
> I've read that Linux-IRDA should be turned off in order to use gnokii
> and so I've turned it off.

No, that's only for the ancient phones.

In short:
 - enable linux irda
 - tune .gnokiirc as shown above
 - compile gnokii with debug enabled
 - show the result of gnokii --identify

pkot
-- 
mailto:address@hidden :: mailto:address@hidden
http://kt.linuxnews.pl/ :: Kernel Traffic po polsku