actisys 220L+ serial dongle / nokia 6100: Couldn't open PHONET device: No route to host

[Johannes Zellner]

Hello,

I've the following probem:

    # gnokii --identify
    GNOKII Version 0.5.5
    connect: No route to host
    Couldn't open PHONET device: No route to host
    Telephone interface init failed: Command failed.
    Quitting.

My setup is:

    - Linux 2.6.0-test11
    - gnokii-0.5.5
    - mobile: Nokia 6100
    - Actisys 220L+ serial dongle

I modules are loaded correctly (I think):

    # lsmod
    Module                  Size  Used by
    ircomm                 17024  0
    actisys                 2944  0
    irtty_sir               6720  2
    sir_dev                14780  1 irtty_sir
    irda                  164024  5 ircomm, actisys,irtty_sir,sir_dev,irport

and I did

    # irattach /dev/ttyS0 -s -d actisys+


apparently I can get a connection to my mobile:

    # irdadump
    22:25:28.896903 xid:cmd 9b79ec74 > ffffffff S=6 s=0 (14)
    22:25:28.986881 xid:cmd 9b79ec74 > ffffffff S=6 s=1 (14)
    22:25:29.068864 xid:rsp 9b79ec74 < 00001da1 S=6 s=1 Nokia 6100 hint=b125 [ 
PnP Modem Fax Telephony IrCOMM IrOBEX ] (27)
    22:25:29.076866 xid:cmd 9b79ec74 > ffffffff S=6 s=2 (14)
    ...


My ~/.gnokiirc is:

    port = /dev/ircomm0
    model = 6510 # also tried 6100 with no difference
    connection = irda


If I don't start the infrared connection on my mobile, the
"gnokii --identify" command gives a timeout instead.


To summarize:
Apparently I can connect to the mobile, as
    1. irdadump shows it
    2. gnokii behaves differently wether infrared is enabled at the mobile
but gnokii is not working anyway.

What did I make wrong?
Any help much appreciated!

-- 
Johannes