About FBUS

[Eduardo Garcia]

Hi Marky.
Sorry importune you again, but can you send me the schematic used for you to
interface the AVR to Phone via FBUS.


Thanx,
Eduardo Garcia
----- Original Message -----
From: Mark V
To: Eduardo Garcia ; Discussion forum for gnokiiusers.
Sent: Tuesday, February 18, 2003 9:44 AM
Subject: Re: How detect incoming call?????


Eduardo,

I have written code to authenticate using BASCOM on a ATMEL microcontroller.

In my experimentation, I found that you didn't need to authenticate, but the
Set Cell Broadcast had to be sent to the phone, and after this, incoming
call notification came through.

If you are interested, you can check out http://www.mcselec.com/an_124.htm
for an application note I have 'thrown' together.  Due to limited memory in
microcontoller, and because I was using Basic, and not assembly, I could not
fit everything into 8K memory.

Note, I used FBUS, and not MBUS, but I assume that the packets/packet order
are very similiar.

HTH

Mark Voevodin
----- Original Message -----
From: "Eduardo Garcia" <address@hidden>
To: "Osma Suominen" <address@hidden>
Cc: "Discussion forum for gnokii users." <address@hidden>
Sent: Tuesday, February 18, 2003 9:55 PM
Subject: Re: How detect incoming call?????


>
> > How can I detect a incoming call in this cell phones (6120, 5120 and
3280
> > are the models that I using now. I think that 51XX and 61XX models are
> very
> > similar) using MBUS protocol with a MICROCONTROLER (Microchip PIC more
> > exactly) managing it through USART??


---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.456 / Virus Database: 256 - Release Date: 18/02/03