Re: [Getfem-users] Segmentation fault (core dumped)

[Konstantinos Poulios]

Dear Zhenghuai Guo,

What version of GetFEM are you running? Is it possible to share your crashing code with us or even better a minimal code that reproduces the segmentation fault?

BR

Kostas

P.S. please send your messages only to the list address.

On Sun, May 5, 2019 at 4:27 PM Zhenghuai Guo <address@hidden> wrote:

Hi, Konstantinos and Yves  and Andriy,

I use gmsh to make meshes. In case 1, I generate triangle elements. In case 2, I use the recombine function in
gmsh to generate quadrangle elements - it is actually mixed quadrangle and triangle elements, but majority is quadrangle elements.
This reduces the mesh size.

I run the exact same code. In the code I only add linear_elasticity_brick:
  getfem::add_isotropic_linearized_elasticity_brick(model, mim_1, "u_1", "lambda_1", "mu_1");
  getfem::add_isotropic_linearized_elasticity_brick(model, mim_2, "u_2", "lambda_2", "mu_2");

and Dirichlet_condition

  model.add_initialized_fixed_size_data("Dirichlet_value", base_small_vector(0,0.));
  getfem::add_Dirichlet_condition_with_multipliers(model, mim_1, "u_1", mf_u_1, total_bounday_1,"Dirichlet_value" );
  getfem::add_Dirichlet_condition_with_multipliers(model, mim_2, "u_2", mf_u_2, total_bounday_2,"Dirichlet_value" );

no source term, no mass term

The code runs ok for meshes of the case 1 and case 2.

But, if I add the contact_brick  as below, only the meshes of the case 1 is ok.
 ind = getfem::add_integral_large_sliding_contact_brick_raytracing(model, "1", release_dist, "0", "1", false); ///
  getfem::add_contact_boundary_to_large_sliding_contact_brick(model,ind,  mim_contact_1, total_bounday_1, true, true, "u_1", "pre_mflambda_1");
  getfem::add_contact_boundary_to_large_sliding_contact_brick(model,ind,  mim_contact_2, total_bounday_2, true, true, "u_2", "pre_mflambda_2"); ///

When I use meshes of the case 2, it gives an error of
Trace 2 in getfem_models.cc, line 2698: Global generic assembly RHS
Segmentation fault (core dumped)

Could you please advise about this?

Thank you very much
Regards
Zhenghuai Guo