I looked at example1.c and its passing this in with the params arg for
FT_Outline_Render.
I'm calling FT_Render_Glyph. Any idea how I can setup a callback in
this case?
On 2/5/2010 11:52 AM, Bruce Long wrote:
To register the call-back just set
params.gray_spans=(FT_SpanFunc)yourCallBack.
I believe that example1.c does this and even provides a sample
call-back that implements the threshold you are talking about.
Bruce
On Fri, Feb 5, 2010 at 6:21 AM, Dave Calkins
<address@hidden>
wrote:
On
1/31/2010 6:08 PM, Bruce Long wrote:
If you are using the 'grays' renderer you could always use the
call-back routine. Then instead of assigning a value from 0 to 255 use
a scaling factor to push the values closer to 255. Of course you glyphs
will look a little fatter.
For example, add (say) 64 to each pixel value then if the result is
> 255, set it to 255.
Or, multiply the pixel value by (say) 1.5. Then set any values >255
to 255.
(Tor, sorry I sent that to only you instead of reply -all.)
I'll give this a try. Where/how do you register the callback routine?
As for "fatness" of the glyphs, maybe instead of pushing the values
brighter, I could have a threshold and zero out anything below that
threshold?
--
Give me immortality or give me death!
|