On Thu, Dec 15, 2011 at 2:17 AM, Salvador H-V <
address@hidden> wrote:
> Dear All,
>
> I am trying to simulate a system using DPD thermostat.
>
> In the user guide i found the following sentence: "... before using dpd, you
> have to stop the center of mass motion of your system, which
> you can achieveby using the command galileiTransformParticles. This may be
> repeated once in a while for long runs due to round off errors (check this
> with the command system_com_vel) "
>
> I did no find more information about these two commands.
> I would appreciate any help of how to apply both commands inside an ESPResSo
> simulation. What is the syntaxis?
>
> By the way, using the 2.1.5 version of ESPResSo I observed some unexpected
> behavior for a single dumbbell system using DPD thermostat. The dumbbell
> seems to translates and rotates only in one direction. When I use the
> Langevin thermostat it seems to perform both translation and rotation
> random/brownian movement. I using the same system with both thermostats.
> Any comment will be greatly appreciated.
>
> Thans a lot,
>
> Salvador H-V
>
>
>
>
>
> --
> =o=o=o=o=o=o=o=o=o=o=o=o=o=o=o=o=o=o=o
>
> Dr. Salvador Herrera Velarde
> Division de Ciencias e Ingenierias
> Campus Leon
> Universidad de Guanajuato
>
> =o=o=o=o=o=o=o=o=o=o=o=o=o=o=o=o=o=o=o
>
> Este correo ha sido editado para evitar el uso de acentos y guardar
> compatibilidad entre
> diferentes distribuciones
>
>