[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Highlighting rectangles?
From: |
Ehud Karni |
Subject: |
Re: Highlighting rectangles? |
Date: |
Thu, 1 Nov 2001 13:32:28 +0200 |
On Wed, 31 Oct 2001 14:56:32 -0700 (MST), Richard Stallman <address@hidden>
wrote:
>
> I have 3 commands for marking, 1 for each type. The highlighting is
> done according to the mark type.
>
> I guess this is how it would have to be done. What happens though
> if you ask to mark a rectangle and then type C-w? Or if you ask
> to mark linear text and then use C-x r d?
My marking system signal error if the 1st mark type != 2nd mark type.
It check the mark type and give an error message if the type does not
match the operation.
Ehud.
--
Ehud Karni Mivtach - Simon Insurance /"\
Tel: +972-3-7966-561 Fax: +972-3-7966-667 \ / ASCII Ribbon Campaign
(USA) Fax and voice mail: 1-815-5509341 X Against HTML Mail
Better Safe Than Sorry / \
mailto:address@hidden http://www.simonwiesel.co.il
- Re: Highlighting rectangles?,
Ehud Karni <=
- Re: Highlighting rectangles?, Richard Stallman, 2001/11/01
- Re: Highlighting rectangles?, Ehud Karni, 2001/11/02
- Re: Highlighting rectangles?, Richard Stallman, 2001/11/02
- Re: Highlighting rectangles?, Ehud Karni, 2001/11/02
- Re: Highlighting rectangles?, Richard Stallman, 2001/11/03
- Re: Highlighting rectangles?, Ehud Karni, 2001/11/04
- Re: Highlighting rectangles?, Richard Stallman, 2001/11/05
- Re: Highlighting rectangles?, Ehud Karni, 2001/11/05
- Re: Highlighting rectangles?, Richard Stallman, 2001/11/05