[Dvdrtools-users] toshiba sd-r5002 won't do the job...

[magnus kulke]

hey, 

i just bought a new dvd-rw burner, toshiba sd-r5002. i tried to burn dvd-rs 
and i came up til the '0 mb of 3000mb written' message. shortly after that, 
it crashes the whole system apperently without writing anything to the dvd-r. 
i tried to blank a dvd-rw and got the following output:

x:/home/x/Video # dvdrecord -v dev=0,0,0 blank=all
dvdrtools v0.1.3
Portions (c) 2002-2003 Ark Linux <address@hidden>
Based on:
Cdrecord 1.11a15 (i686-pc-linux-gnu) Copyright (C) 1995-2001 Jörg Schilling
TOC Type: 1 = CD-ROM
scsidev: '0,0,0'
scsibus: 0 target: 0 lun: 0
Linux sg driver version: 3.1.24
Using libscg version 'schily-0.5'
atapi: 1
Device type    : Removable CD-ROM
Version        : 0
Response Format: 2
Capabilities   :
Vendor_info    : 'TOSHIBA '
Identifikation : 'DVD-ROM SD-R5002'
Revision       : '1M31'
Device seems to be: Generic mmc2 DVD.
Using generic SCSI-3/mmc DVD-R(W) driver (mmc_mdvd).
Driver flags   : SWABAUDIO BURNFREE
Supported modes: PACKET SAO
Drive buf size : 1723392 = 1683 KB
Current Secsize: 2048
  ATIP start of lead in:  -150 (00:00/00)
Disk type:    unknown
Manuf. index: -1
Manufacturer: unknown (not in table)
Blocks total: 2298496 Blocks current: 2298496 Blocks remaining: 2298646
Starting to write CD/DVD at speed 1 in write mode for single session.
Last chance to quit, starting real write in 0 seconds. Operation starts.
Performing OPC...
Blanking entire disk
dvdrecord: Input/output error. blank unit: scsi sendcmd: no error
CDB:  A1 00 00 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 03 00 00 00 00 0A 00 00 00 00 0C 00 00 00
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x0C Qual 0x00 (write error) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 1.536s timeout 9600s
dvdrecord: Cannot blank disk, aborting.

anyone got a clue, how to use my dvd burner in linux?

thanks in advance, 

magnus