[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: OpenStep: Advice Needed
|
From: |
Erik M. Buck |
|
Subject: |
Re: OpenStep: Advice Needed |
|
Date: |
Mon, 26 Nov 2001 18:00:37 -0600 |
I run Openstep Mach/4.2 on a 1.8 GHz Pentium IV with 512Mb, IDE/ATAPI
drives, 100Mb Zip drive, Matrox Millenium Graphics, and 3Com 10/100
ethernet. I also use Cogent ethernet cards with Intel chip-sets.
The graphics card is the limitation. New cards do not have drivers. There
is no AGP support. PCI addressing can get messed up when more than 128 Mb
are used. Some hacking in Bios to move the graphics card to higher
addresses may be needed. The 3Com card is 3-4 years old also... There may
be issues with new cards.
The system works well and is very fast. We dual boot to NT2000.
----- Original Message -----
From: "Richard van Paasen" <rvpaasen@dds.nl>
To: <discuss-gnustep@gnu.org>
Sent: Monday, November 26, 2001 5:21 PM
Subject: Re: OpenStep: Advice Needed
>
> Does anyone know where I can find a hardware compatibillity
> list for OpenStep 4.2 ? Will it run, for example, on a Pentium III
> with (E)IDE/ATAPI drives, a TNT2 video card and a 3COM
> ethernet card?
>
> - Richard.
>
>
>
>
> _______________________________________________
> Discuss-gnustep mailing list
> Discuss-gnustep@gnu.org
> http://mail.gnu.org/mailman/listinfo/discuss-gnustep
>
>