[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: ZMQ Message Debug
From: |
Marcus Müller |
Subject: |
Re: ZMQ Message Debug |
Date: |
Sun, 7 Mar 2021 21:41:47 +0100 |
User-agent: |
Mozilla/5.0 (X11; Linux x86_64; rv:78.0) Gecko/20100101 Thunderbird/78.8.0 |
Hi Jay,
first of all: that's GNU Radio 3.7. Time to upgrade, really! No excuse. You're
building a
new something, and you're starting with something that has been legacy for
years now.
ZMQ and networking blocks have seen many improvements, so, you're really
ill-advised to
stick with GNU Radio 3.7
Then: puh, this is incredibly complex. When debugging something, reduce to as
little
blocks as necessary to reproduce the problem. You've not done that, and I
really can't
tell where the problem here lies!
Best regards,
Marcus
On 07.03.21 21:06, Jay Patel wrote:
> Hi all,
>
> I am sending messages from an external application via (ZMQ PUSH) and
> received those
> messages in the GNURadio via ZMQ Pull message source.
>
> From the ZMQ PULL side, I had correctly debugged the message coming from
> external
> applications.
>
> I want to basically transmit those messages. But in the receiver side after
> the Tagged
> stream to PDU -> message debug block don't print anything. I put a QT Freq
> sink to check
> if the data is coming properly or not.
>
> Did I miss something? How can I properly debug the messages. I had attached
> my flow graph.
>
> Any suggestions are welcome.
>
> */With Regards,/*
> /Jay Patel/
>