You
should probably use an add block instead of Streams to Stream.
Here's an example flow graph.
Ron
On 12/21/20 11:20, George Edwards wrote:
> Hello,
>
> I have three signals routed to the Gnuradio Polyphase
Channelizer
> Block. The system operates at a sample rate of 90 kHz
with 3 channels
> spaced 25 kHz apart. One channel is centered around DC
and the other
> two at +/-25 kHz. The 3 waveforms are routed into a
Gnuradio Streams
> to Stream Block, so that a simple concatenated stream
flows into the
> Gnuradio Polyphase Channelizer. I also set the
Channelizer Block to
> use 120 Taps and provide 3-outputs. Here are my questions
on observing
> the outputs
>
> Q1. I was expecting each output (block set to 3 outputs)
to be at the
> sample rate (90 kHz/3 =) 30 kz in each of the 3-plots.
The plots show
> a sample rate based on the original rate of 90 kHz. Why
is this?
>
> Q2. I expected each output waveform to be centered around
DC, but they
> were instead centered around -25 kHz. Why?
>
> Q3. The output bandwidth for each waveform seems a little
bigger than
> the input, why?
>
> I will appreciate any help that assists to point me in
the right
> direction.
>
> Regards,
> George