Hello I am trying to install RFNoC for uhd 3.15. As far as I understand, this version supports RFNoC. And in order for me to have blocks in gnuradio, as I understand it, I need to install gr-ettus. But when installing, I get this error The found UHD version (126.96.36.199-3build2) is not compatible with the version
required (4.0). how can I be in such a situation?
The TX/RX and RX2 are ports on the same receiver channel. As Julian says
there are two receivers, A and B. For a receive only application the RX2
ports are slightly better performing as they have one less switch that
the signal passes through.
On 18/11/2020 14:01, Julian Arnold wrote:
> to the best of my knowledge, there should not be any RX1 port.
> Instead, you should have two (coherent) channels "A" and "B" both
> allowing you to select one out of two available antenna ports when
> receiving ("TX/RX" or "RX2").
> On 11/18/20 10:31 AM, Ivan Zahartchuk via USRP-users wrote:
>> Another question of interest is which channels are coherent? Rx1 and
>> RX2 or RX1 and RX / TX?
>> вт, 17 нояб. 2020 г. в 01:56, Ivan Iudice <email@example.com
>> Be careful, DOA estimation using only 2 antennas works but it’s not
>> so accurate.
>> > Il giorno 17 nov 2020, alle ore 00:35, Ivan Zahartchuk
>> <firstname.lastname@example.org <mailto:email@example.com>> ha scritto:
>> > That is, in theory, I can simply start two streams from two
>> channels and further process them using certain direction finding
>> USRP-users mailing list
USRP-users mailing list