[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Discuss-gnuradio] Wifi receiver - where do I dump the WiFi PHY Hier out

From: Eamon Heaney
Subject: [Discuss-gnuradio] Wifi receiver - where do I dump the WiFi PHY Hier out?
Date: Wed, 5 Jun 2019 18:08:29 -0400

Hi y'all,

I'm trying to get a wifi transceiver working with HackRF and gnuradio, specifically using the tools from this github repo: https://github.com/bastibl/gr-ieee802-11 

It comes with an example transceiver .grc, but made with USRP instead of osmocom. I changed the source to osmocom (parameters are mostly the same), and disabled the sink, since HackRF is only half-duplex. Only problem is, now I've got this "Wifi PHY Hier" block that's angry at me because I disabled its output target.

What can I plug in there, just as a placeholder while I verify the reception end? The flowgraph output is colored blue in the gui, if that helps.


Eamon Heaney
Fleet Commander
President, Model UN at Virginia Tech

reply via email to

[Prev in Thread] Current Thread [Next in Thread]