[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Create a "virtual" variable using outputs from an
From: |
CEL |
Subject: |
Re: [Discuss-gnuradio] Create a "virtual" variable using outputs from another block |
Date: |
Fri, 17 May 2019 13:40:33 +0000 |
It's possible through the "Probe" thing; I don't like that block,
because it leads to bad flowgraph design in 90% of cases.
However, it should solve the problem you're having :)
Best regards,
Marcus
On Fri, 2019-05-17 at 13:31 +0000, tom sutherland wrote:
> Is there a way to take the output from a block and make it appear as though
> that signal is a variable? e.g. take the output from a “signal source” block
> and sink it into a block that creates a “variable” named ‘myfreqvar”. Then
> use “myfreqvar” as a parameter in other blocks.
> Tom
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
smime.p7s
Description: S/MIME cryptographic signature