Re: [Discuss-gnuradio] No change when set_processor affinity() is used

[Marcus D. Leech]

On 05/12/2015 12:52 PM, Nemanja Savic wrote:

You are probably right, cause that file doesn't even exist. I looked at default gnuradio-core.conf in conf.d.

I suppose that something like that should be written in gnuradi-core.conf, but really nothing.

Where can I find which option should be added?

How are you determining that this is only occupying a single core?

Are you running on a VM?   If so, how many cores does your VM simulate?

On Tue, May 12, 2015 at 6:33 PM, Marcus D. Leech <address@hidden> wrote:

On 05/12/2015 12:25 PM, Nemanja Savic wrote:

Hi all guys,

I have a flowgraph where I have three parallel paths for filtering signal stored in a file. Here the picture of my flowgraph:

I use gnuradio 3.6.5.1. When I run the script it uses only one processor, and since I have 4 cores, I would like to run every of the paths on another processor. For every filter I do set_processr_affinity[some number between 0 and ]. When I run the script nothing changes, it still runs on a single core. Am I missing something with set_processor_affinity method?

Best,

--

Nemanja Savić

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

My guess is that your ~/.gnuradio/config.conf   specifies to use the single-threaded scheduler.

--

Nemanja Savić