Re: [Discuss-gnuradio] usrp2 on windows - network cable unplugged

[Kyle Zhou]

> -----Original Message-----
> From: Marcus D. Leech [mailto:address@hidden
> Sent: Thursday, 18 August 2011 2:16 PM
> To: Kyle Zhou
> Cc: address@hidden
> Subject: Re: [Discuss-gnuradio] usrp2 on windows - network cable
> unplugged
> 
> On 08/18/2011 12:09 AM, Kyle Zhou wrote:
> >
> > Yes, I did configured it as static IP 192.168.10.1
> > Actually windows did show 'connected, firewalled'. but after a few
> > seconds, it turned to unplugged. This is weird to me.
> Well, if it really is configured for a static IP, you might see if
> there's a way to force the card to only use
>   1GiGe.  I don't know how to do that in windows, but I do know that
> some 1GiGe PHY implementations
>   don't auto-negotiate properly, so if you can force the ethernet
> hardware to run always at 1GiGe, and
>   not auto-speed negotiate, that sometimes helps.
> 
> 
> 
> --
> Principal Investigator
> Shirleys Bay Radio Astronomy Consortium
> http://www.sbrac.org
> 
Yes, you are right. When I configure the Ethernet interface to the 1Gb only
mode. It works!
Thanks a lot.