Re: [Discuss-gnuradio] read_aux_adc

[jf w]

I'm using RFX2400 daughterboard on side B, my arguments are  slot=2 which_adc = 0 ,and I'm calling it from python.

Your question inspire me that my arguments may be wrong. I think the slot argument should be 3(SLOT_RX_B), but I don't know the meaning of which_adc and how to set it.  

There are two aux_adc on one ad9862:aux_adc_a and aux_adc_b , but there are four pins : aux_adc_a1,aux_adc_a2, aux_adc_b1 and aux_adc_b2. But what is the input of the signal on these pins?

Thanks a lot.

2010/5/31 Eric Blossom <address@hidden>

On Mon, May 31, 2010 at 11:00:17AM +0800, jf w wrote:
> hi all,
>
> I want to use the read_aux_adc method to get the RSSI, but the results I got
> seem meaningless.
>
> 1. Everytime I call the read_aux_adc, the result increases step by step.
> 2. No matter whether there is a sender, the result is the same.
>
> Does anyone come up against this problem ?
> Any suggestion is helpful to me.

What daughterboard are you using?
Which side is it installed in, side A or side B?
What argument values are you passing to read_aux_adc?
Are you calling it from C++ or Python?

Eric

--
Thanks,
Jianfei
BUAA