[Discuss-gnuradio] (USRP) WBX Daughterboard ESD Protection?

[James Stein]

I’d be grateful for some information about the level of electro-static discharge (ESD) protection on the RF inputs to the WBX daughterboard for the USRP/USRP2 (with granddaughter-board installed).

 

In particular, is it likely to be susceptible to static build-up on an open circuit antenna?

 

Thanks.

 

James

---

This E-mail is the property of Mass Consultants Ltd. It is confidential and intended only for the use of the addressee or with its permission.  Use by anyone else for any purpose is prohibited.  If you are not the addressee, you should not use, disclose, copy or distribute this e-mail and should notify us of receipt immediately by return e-mail to the address where the e-mail originated.

 

This E-mail may not have been sent through a secure system and accordingly (i) its contents should not be relied upon by any person without independent verification from Mass Consultants Ltd and (ii) it is the responsibility of the recipient to ensure that the onward transmission, opening or use of this message and any attachments will not adversely affect its systems or data. No responsibility is accepted by Mass Consultants Ltd in this regard.

 

Any e-mails that are sent to Mass Consultants Ltd's e-mail addresses may be monitored by systems or persons other than the addressee, for the purposes of ascertaining whether the communication complies with the law and Mass Consultants Ltd's policies.

 

Mass Consultants Ltd is registered in England No. 1705804, Grove House, Rampley Lane, Little Paxton, Cambs., PE19 6EL, United Kingdom. Tel: +44 (0) 1480 222600.

---