Re: [Discuss-gnuradio] Measurement Computing DAC and USRP on the same programming language in Windows.

[Eric Blossom]

On Sat, Jul 04, 2009 at 02:43:10PM +1000, Shabbir Ahmed wrote:
> Dear all:
> 
> I need to run Measurement Computing DAC in parallel to GNURADIO/USRP. The
> DAC feeds to a variable gain aplifier. I want to use the USRP as a receiver
> and measure the strength of the signal. Feed the result into a code which
> will determine the control voltage required by the valirable amplifier.
> Now the problem is that I measurement computing DAC only runs in windows,
> drivers are only for windows, and I have been coding in C++. Any ideas how
> to run both the USRP and the DAC on the same programming language, and on
> Windows Platform.
> 
> Would really appreciate your help. Thank you loads in advance.
> 
> Kind regards,
> 
> -- 
> Shabbir Ahmed
> PhD. Student
> Centre for Telecommunications and Microelectronics
> Victoria University
> Email: address@hidden

The COMEDI project may support your Measurement Computing DAC board
under Linux.  See 

  http://www.comedi.org
  http://www.comedi.org/hardware.html

Eric