Re: [Denemo-devel] Ukulele fret diagrams

[Richard Shann]

On Tue, 2016-06-14 at 14:30 +0100, Joe Wilkinson wrote:
> Thanks Richard.
> 
> I had a try with the documentation, but was struggling. I will persist.

it sounds like you already got to the point where you would be welcomed
with open arms if you asked on address@hidden
When asking there it is best to create a small example without all the
fancy stuff that Denemo adds. If you can figure out what the output
LilyPond should look like it won't be a problem to create it from Denemo
I'm sure.

> 
> I am not that fussed about putting the Chord diagrams into the music 
> with the chord names - things can get cluttered.

I think you are talking about their examples, e.g.

\include "predefined-ukulele-fretboards.ly"
myChords = \chordmode { a1 a:m a:aug }
\new ChordNames {
  \myChords
}
\new FretBoards {
  \set Staff.stringTunings = #ukulele-tuning
  \myChords
}

The only reason this prints the chord names is it has the \new
ChrodNames { ....} block there to print them.

You just delete that bit, as I did in my example.

> But it would be nice to have a list of those in use in the music at the 
> top or bottom.
> Would it be best to put them in a separate movement?

That's a possibility. Otherwise you could use the Create Gap command and
start them after the music (I expect).

Richard