Re: [Denemo-devel] No audio or print on Denemo, can you please help?,

[Richard Shann]

On Tue, 2016-05-10 at 11:44 +0100, Bernard Bourdillon wrote:
> Thanks for this
> Please, how do I find out what architecture I'm using?

the downloads page now has the correct instructions, avoiding needing to
know the obscure terminology - amd64 and i386 are just historical names
which read literally would seem to be talking about Intel and AMD
processors...

Richard



>  The web seems to 
> imply that Linux and amd64 go hand in hand.
> Bernard
> 
> On 10/05/16 10:03, Andreas Schneider wrote:
> > Am 10.05.2016 um 10:48 schrieb Richard Shann:
> >> On Tue, 2016-05-10 at 09:30 +0100, Bernard Bourdillon wrote:
> >>> Andreas: at one point you refer to 4 packages. Should I only be copying 
> >>> over the packages with 2.0.6 in the title?
> >>>
> >>> Richard: the Denemo download site [http://www.denemo.org/downloads-page/] 
> >>> has this last command as
> >>> sudo dpkg -i *denemo*2.0.6*_amd64.deb
> >>> I guess this should be amended with the addition of 
> >>> *denemo*2.0.6*_all.deb ?
> >> yes, I spotted that this morning while I was fixing the instructions for
> >> the mysterious "run" command :)
> > Yes, what you need is:
> >   denemo_version_architecture.deb
> >   denemo-data_version_all.deb
> >   ttf-denemo_version_all.deb
> >   denemo-doc_version_all.deb
> > where you have to replace version with the version you want to install
> > (e.g. 2.0.6) and architecture with the architecture you are using (amd64
> > or i386). Those four packages have to be installed with
> >   dpkg -i packagename
> > where packagename has to be replaced by the file names of the packages
> > to install. The systax on the homepage is just one version to give these
> > 4 filenames without having to type everything.
> > There are still packages for version 2.0.4 online. I should delete them
> > to avoid confusion.
> >
> > Andreas
> >
>