Re: ddd --args doesn't work

[Cal Erickson]

In the pull down for program is the run command. When this is selected
you can enter your arguments. The next time you want to run with those
same arguments they are retained. If you save the session then the
commands are retained and can be re-used.

Cal

Tim Combs wrote:

> Another options would be to start up ddd with the program and
> do a 
> run -arg1 -arg2 -arg3
>
> on the gdb command line in the bottom window.
>
> Tim
> On Mon, May 19, 2003 at 01:42:34PM +0100, Garret Brady wrote:
>
> > I would like to debug a program which is run as follows:
> >
> > <proganme> -arg1 -arg2 -arg3
> >
> > Running
> > ddd --args <proganme> -arg1 -arg2 -arg3
> >
> > doesn't pass -arg1, -arg2 or -arg3 to gdb.  Can anyone help?
> >
> > garret.
> >
> >
> > --
> > Garret D. Brady -----------------------------------------------
> > Magnetics & Machines Group, University College Dublin, Ireland.
> > http://elecmag3.ucd.ie/~gbrady             Tel: +353-1-716-1959
>
>
> _______________________________________________
> Ddd mailing list
> address@hidden
> http://mail.gnu.org/mailman/listinfo/ddd


--
===========================================================================
Cal Erickson                 MontaVista Software Inc.
Linux Consultant             1237 E. Arques Ave.
Phone (408) 328-0304         Sunnyvale CA 94085
Fax   (408) 328-9204         web http://www.mvista.com
===========================================================================