Re: Makeing ddd on Caldera (SCO) OpenServer 5.0.X problem...

[Boyd Lynn Gerber]

See below. I also got this message too.

On Wed, 19 Dec 2001, Boyd Lynn Gerber wrote:
> I configure ddd and then run make and it always stops.  Here...
> /bin/sh ./libtool --mode=link g++  -DNDEBUG -O2 -g -W -Wall -trigraphs   -o 
> stringify  stringify.o
> g++ -DNDEBUG -O2 -g -W -Wall -trigraphs -o stringify stringify.o
> make[2]: Entering directory `/usr/zenez/build/osr5/ddd-3.3.1/ddd'
> + gcc -DHAVE_CONFIG_H -I. -I. -I. -I./.. -g -belf -c -g ./ctest.c -o ctest.o
> gcc cannot find crtbegin.o: No such file or directory
> gcc: file path prefix `/usr/local/gcc-2.95.3/lib/gcc-lib/elf/2.95.3/' never 
> used
> make[2]: *** [ctest.o] Error 1
> make[2]: Leaving directory `/usr/zenez/build/osr5/ddd-3.3.1/ddd'
> make[1]: *** [ctest.o] Error 2
> make[1]: Leaving directory `/usr/zenez/build/osr5/ddd-3.3.1/ddd'
> make: *** [all-recursive] Error 1

or

/bin/sh ./libtool --mode=link gcc  -g -O2 -belf  -o ctest  ctest.o
gcc -g -O2 -belf -o ctest ctest.o
crtbegin.o: fatal error: cannot open file for reading
gcc: file path prefix `/usr/local/gcc-2.95.3/lib/gcc-lib/elf/2.95.3/'
never used

make[1]: *** [ctest] Error 1
make[1]: Leaving directory `/usr/zenez/build/osr5/ddd-3.3.1/ddd'
make: *** [all-recursive] Error 1

--
Boyd Gerber <address@hidden>
ZENEZ   3748 Valley Forge Road, Magna Utah  84044