Re: [Dataexplorer-help] Dataexplorer-help post from address@hidden requires approval

[yohan cellette]

Hi  winfried,

Thanks for your answer i will try your solution it's seem you are able to read my sample great ! thanks a lot !

In fact the data are no exactly coming from a real graupner Hott device.

 I use a small arduinio and cheap gps who create "graupner hott V4" frame  and send it to my radio via the recepter. ( it s possible that somes data are not exactly the same )
 the code is diy hott gps: https://code.google.com/p/diy-hott-gps/

So i supposed you are right about the "altitude" i don't know yet how to make the "zero" but i will look after it should use the gps altitude because i dont have vario .
But the project look to work pretty well the position seem to be correct. (i display it on google map )

May be some improvement to do but for 6$ it nice ( i already have the gps )

 

2015-01-03 21:41 GMT+01:00 Winfried Brügmann <address@hidden>:

Hi Yohan,

all your assumptions are correct. Great idea to pass a sample file for cross checking. I had a look into your attached file and found the measurement values from Climb are below an acceptable value and therefore all your GPS data are blanked out. You can workaround this filter by deactivating it. Open the device dialog and uncheck the filter settings. Do not forget to save afterwards. Just re-try to import your file again.
I wonder why your altitude values are starting at 180 m above ground. This is the possible reason why you run into this problem. Height (relative altitude), and climb values are not GPS based and should reset and start to zero since it is air pressure based.

Hope I could help, have a nice time

Winfried

On 03.01.15 14:18, address@hidden wrote:

Subject:

dateexplorer is working with hott v4 telemetry data ?

From:

yohan cellette <address@hidden>

Date:

03.01.15 14:18

To:

address@hidden

Hi guys,

this is my first post on the list.

I discovered the dataexplorer on the web and i try to make it work
with my mx16 hott telemetry V4.

My bin file are working on the ugly graupner soft but it's seem data
explorer is better.

My problem is that i can't export all data from bin file. receiver
part is working but gps data are not present. I suppose that the
problem come from the bin format who is may be not good in V4 ?? Can
you confirm or help me to configure the soft to read my bin file ?
espcially the gps part.

Thanks for help
yohan

please find include a sample of data