[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Line mode
From: |
Mike Aubury |
Subject: |
Line mode |
Date: |
Sat, 31 Jan 2004 10:36:12 +0000 |
If I run a program with TERM=vt100 and have some display in screen mode, then
switch to line mode, the screen mode display is scrolled up and my line mode
display is put at the bottom..
If I run the same program with TERM=xterm, the screen mode display disappears
and is replaced by a copy of the screen *before* the screen mode was
initiated and the display is put at the bottom.
What terminfo/termcap setting is used to specify this latter behaviour ?
(And is there anyway to turn it off - so I get the display like TERM=vt100
when using xterm without having to change the terminfo/termcap entry!)
- Line mode,
Mike Aubury <=