[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Not able to map hd1->hd0 for booting Windows on hd1
From: |
Ground Zero |
Subject: |
Re: Not able to map hd1->hd0 for booting Windows on hd1 |
Date: |
Wed, 28 Jul 2004 19:49:24 +0300 |
Let's summarize all the alternative booting options that have been proposed
to me and the outcome. I'm trying to boot Windows98 from the 2nd hard-disk
where it has a classic setup (C on primary, D on logical in extended):
CASE 1:
map (hd0) (hd1)
map (hd1) (hd0)
rootnoverify (hd1,0)
chainloader +1
makeactive
or
root (hd1,0)
map (0x81) (0x80)
map (0x80) (0x81)
makeactive
chainloader +1
OUTCOME: Guess what, that freeze was only apparent. It wasn't a freeze, just
a very long (15-20 seconds) delay. After that the second drive does boot, but
it has my old problem: the extended partition is not recognized (DOS fdisk
shows type UNKNOWN instead of FAT32). This, remember, even though I've
changed the motherboard with a completely different product.
********
CASE 2:
root (hd0,0)
chainloader +1
OUTCOME: boots the 1st hard disk, 1st partition, which is my /boot and has
some leftover LILO on its boot sector.
********
CASE 3:
root (hd1,0)
makeactive
chainloader +1
or
root (hd1,0)
makeactive
chainloader (hd1,0)+1
OUTCOME: these ones don't use map and they really produce a freeze.
********
I also tried booting from a floppy, as suggested. When the Window disk is
slave, same outcome as above. When it is master it boots immediately (no
delay) and D: is recognized properly.
--
GZ