[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[grub #25] Grub does not boot on LH3 integrated HP NetRaid
From: |
per . sil |
Subject: |
[grub #25] Grub does not boot on LH3 integrated HP NetRaid |
Date: |
Tue, 14 Jan 2003 16:40:39 +0900 |
Reporter: address@hidden
Summary: Grub does not boot on LH3 integrated HP NetRaid
Version: 0.92 and 0.90
Type: software bug
Message:
I am trying to boot a 2.4.19 linux-kernel on a HP Netserver LH3 (PhoenixBIOS:
4.06.43 PL) with integraged HP NetRaid card (bios: B 02.03; firmware: D 03.03).
grub installation ends successfully, typing (in grub-shell)
root (hd0,0)
setup (hd0)
Printout is:
grub> root (hd0,0)
Filesystem type is ext2fs, partitiontype 0x83
grub> setup (hd0)
Checking if /boot/grub/stage1" exists... yes
Checking if /boot/grub/stage2" exists... yes
Checking if /boot/grub/e2fs_stage1_5" exists... yes
Running "embed /boot/grub/e2fs_stage1_5 (hd0)"... 16 sectors are embedded.
succeeded
Running "install /boot/grub/stage1 (hd0) (hd0)1+16 p (hd0,0)/boot/grub/stage2
/boot/grub/grub.conf"... succeeded
Done.
At boot-time, only one line is displayed saying:
GRUB read error
hd0 is an RAID-5 disc-array consisting of 3 drives, handled by the NetRaid
controller. There are no other drives than this one.
I tried using the controller in I2O mode and in mass-storage mode with megaraid
driver. No change in this behaviour! Devicemap identifies drive in I2O mode:
/dev/i2o/hd/disc0/disc and with megaraid driver:
/dev/scsi/host0/bus2/target0/lun0/disc
I tried using grub 0.90 (precompiled by Gentoo-Linux LiveCD 1.2), grub 0.92,
and grub 0.92 with pci-direct enabled. Even --force-lba has no effect.
Do you have any idea how to solve this problem? It is a bit weird to start this
server using a DOS partition and loadlin.
Thanks,
Perolo
----
Please send followups to <address@hidden>.
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [grub #25] Grub does not boot on LH3 integrated HP NetRaid,
per . sil <=