Grub & SCSI - no ide

[Russ M]

The other day I was working on putting Grub into two of my servers.  One
is an HP NetServer LH - with a 4gb Scsi.  The other is a Dual P166 Scsi
+ IDE, Dac960PD Hardware raid.  Both system has dual AIC 7870
controllers as well. 

When I attempt to use the Grub boot disk; it hits stage2 - and
immediately reboots.  If I boot the system through alternative means;
and install grub, it works as expected.  

I have 0 problems on my am 1ghz with 3 ide controllers, but scsi seems
to burb in grub's face..

If this has already been a discussed issue; could somebody point me
towards said info.. If not I'll provide additional information as
required/requested.

Russ (address@hidden)