Re: [avr-gcc-list] Debuging spurious resets in Atmega16 application.

[Matthew Smith]

David Shoemaker wrote:
> Does anyone have a good debug method for figuring out why my ATMega16 is
> resetting while my application is running (a robot).  I can get 20-30
> seconds of run when it is driving but then I get a reset (I have radio
> communications over serial so I can see the startup banner go by again).
> I can then send another run command but it resets again shortly (repeat
> this cycle at will).
>  
> No watchdog, I have the brown out set at 2.7vdc (and off).  This runs as
> long as I want on the bench but put it in the field and I get the resets.
You sure this isn't a hardware issue, rather than a compiler issue?
Will the problem go away if you disconnect any noisy stuff like drive
motors?

Cheers

M

-- 
Matthew Smith
South Australia
http://www.kbc.net.au