[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [avr-gcc-list] end of tool chain (programming)
From: |
John Chris Wren |
Subject: |
RE: [avr-gcc-list] end of tool chain (programming) |
Date: |
Tue, 9 Apr 2002 20:01:48 -0400 |
You don't specify if you want an X-based terminal program or not, but
one
that works quite nicely under both a text and GUI interface is minicom.
It's available on rpmfind.net, and any other typical Linux software
repositories.
--John
> -----Original Message-----
> From: address@hidden [mailto:address@hidden
> Behalf Of Rob Ward
> Sent: Tuesday, April 09, 2002 18:59 PM
> Cc: address@hidden
> Subject: Re: [avr-gcc-list] end of tool chain (programming)
>
>
> Hi. I am looking for a terminal (like hyperterminal) to run under Linux.
> Any ideas? (Need to access the avr serial port on an ethernut).
>
> Rob
>
>
> avr-gcc-list at http://avr1.org
avr-gcc-list at http://avr1.org
- [avr-gcc-list] end of tool chain (programming), Eric Fort, 2002/04/15
- Re: [avr-gcc-list] end of tool chain (programming), joe, 2002/04/15
- Re: [avr-gcc-list] end of tool chain (programming), Eric Fort, 2002/04/15
- Re: [avr-gcc-list] end of tool chain (programming), Jon McClintock, 2002/04/15
- Re: [avr-gcc-list] end of tool chain (programming), Jon McClintock, 2002/04/15
- Re: [avr-gcc-list] end of tool chain (programming), Rob Ward, 2002/04/15
- Re: [avr-gcc-list] end of tool chain (programming), Matthew Welland, 2002/04/15
- RE: [avr-gcc-list] end of tool chain (programming),
John Chris Wren <=
- Message not available
- Re: [avr-gcc-list] end of tool chain (programming), Rob Ward, 2002/04/15
- Re: [avr-gcc-list] end of tool chain (programming), Greg Kulosa, 2002/04/15