[AUCTeX] Re: minibuffer message after C-c C-c

[Sebastian Luque]

Ralf Angeli <address@hidden> wrote:

[...]

> Do you get a backtrace if you do a LaTeX run and type `M-x
> toggle-debug-on-error RET' before starting it?  (See also the answer
> to the question "Why doesn't AUCTeX signal when processing a document
> is done?" in the FAQ section of the manual.)

Unfortunately, none of these gives me a backtrace.


> Are there any suspicious (error) messages in the output buffer
> (accessible with `C-c C-l') or the *Messages* buffer?

Nope, it occurs even in the simplest documents, where there are no errors
in the output buffer, nor in *Messages*. I may have to try my init options
a block at a time to spot this (see below).


> Are you able to observe the problem if you start Emacs with `emacs -q
> -no-site-file', type `M-: (require 'tex-site) RET', open a LaTeX file,
> and compile it?

Here there's no problems, I get the "successfully formatted" message at
the end.

Thanks a lot.

-- 
Sebastian P. Luque