[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Xlog-discussion] testing set_conf for Nate
From: |
Joop Stakenborg |
Subject: |
[Xlog-discussion] testing set_conf for Nate |
Date: |
Thu, 22 Feb 2007 19:42:44 +0100 |
I have tried different hamlib settings (serial_speed and stop_bits)
for the latest xlog version. My rig normally operates at 57600 with
one stop bit. I have set it to some odd value: 4800 Baud and 2 stop bits.
The appropriate line in ~/.xlog/preferences.xml now reads:
<rigconf>serial_speed=4800,stop_bits=2</rigconf>
This works perfectly, no errors!
So Nate, what's next?
I noticed your rig uses write_delay and post_write_delay. Could this be
causing errors? What happens if you use rigctl with a series of commands,
like:
"rigctl -r /dev/ttyUSB0 -m 114 f f f f f m"
Regards,
Joop PG4I
- [Xlog-discussion] Hamlib support in 1.4, Nate Bargmann, 2007/02/05
- Re: [Xlog-discussion] Hamlib support in 1.4, Joop Stakenborg, 2007/02/06
- Re: [Xlog-discussion] Hamlib support in 1.4, Nate Bargmann, 2007/02/06
- [Xlog-discussion] testing set_conf for Nate,
Joop Stakenborg <=
- [Xlog-discussion] Re: testing set_conf for Nate, Nate Bargmann, 2007/02/22
- [Xlog-discussion] Re: testing set_conf for Nate, Nate Bargmann, 2007/02/22
- Re: [Xlog-discussion] Re: testing set_conf for Nate, Joop Stakenborg, 2007/02/23
- Re: [Xlog-discussion] Re: testing set_conf for Nate, Alexandru Csete, 2007/02/23
- Re: [Xlog-discussion] Re: testing set_conf for Nate, Nate Bargmann, 2007/02/23
- Re: [Xlog-discussion] Re: testing set_conf for Nate, Nate Bargmann, 2007/02/24