[Therion] xtherion not responding

[Jonathan Prouty]

Hello all,
I finally commited to upgrading to 0.4.0 (I know, I'm terribly
behind...) because xtherion began to lock up on me. Instead of trying
to identify the problem and fix it, I decided that now was a good
enough time to upgrade. So, I grabbed the new tarball, untarred it, ran
make, then went in to test everything out before I turned it into a
slackware .tgz (my own needless complication. I should go back to
debian, but I digress).

Unfortunately, I still have the same problem that I had under 0.3.9
:-(. When I simply run 'xtherion', the nice little bat splash screen
pops up, tells me it's loading various modules, then loads up the main
xtherion window, as it normally does. However, when I attempt to
interact  with the window, I get no response. Also, when I drag
another window over top of it, the xtherion window wont redraw, which I
take as an indication that it is seriously hosed. In the status bar, it
also says 'User interface is not active. To activate it, open existing
file or create new one'.

If I run 'xtherion /on/a/known/to/work/thconfig.th' it loads up as it
should, with my thconfig.th file in the editor. The window is still
unresponsive however, and won't redraw. I put up an xwd screen dump at
http://www.utc.edu/Students/Jonathan-Prouty/therion.png if anyone would
care to look at it.

I have spent an hour or so trying various things, but to no avail.
Would any of you happen to have any ideas? Thank you very much in
advance.

Sincerely,
Jonny Prouty


_______________________________________________
Therion mailing list
address@hidden
http://www.speleo.cz/mailman/listinfo/therion