Re: [Swarm-Support] question

[Paul Johnson]

Write a BatchSwarm class and run over and over again with different 
parameters passed from the command line.  I have written tutorial addons 
for this, there is a snapshot here,

http://lark.cc.ku.edu/~pauljohn/Swarm/MySwarmCode/tutorial-2.2-pre3.tar.gz

or you can  get from CVS.

Gregoire Boutonnet wrote:
> Hi,
>
> I try to use Swarm since two months and I am happy about the results. But I 
> would like to execute my program a lot of time withe the same initial values 
> without to click on the START button before each loop.
> Is it possible ?
> Because when you want to execute a simulation you have to click the START 
> button and the progrm built the objects and execute the actions. In my case 
> objects and actions are the same for each loop of simulation and it will be 
> better if I don't have to click the START button before each run.
> Thanks a lot for your answer.
>
> Regards
>
> gregoire BOUTONNET


--
Paul E. Johnson                       email: address@hidden
Dept. of Political Science            http://lark.cc.ku.edu/~pauljohn
University of Kansas                  Office: (785) 864-9086
Lawrence, Kansas 66045                FAX: (785) 864-5700