2007/7/23, arnuld <address@hidden>:
> On 7/23/07, Philipp Brüschweiler <address@hidden> wrote:
> You have two possibilities:
> 1. Compile Clisp youself with the mit-clx included (see the stumpwm README);
> or
> 2. Use SBCLinstead
this is from CVS README of Stumpwm:
Build & Start Stumpwm
---------------------
If you intend to use sbcl you need to install portable-clx. If you're
using clisp, make sure it has been compiled with mit-clx. As of clisp
1.41, new-clx is too buggy to run stumpwm. If you want to use new-clx,
build clisp from CVS where the problems have been resolved.
> I use SBCL and everything works fine so far.
even SBCL (on Arch) lacks CLX support :-(
Oops...
Sorry, I forgot you have to install CLX before you build stumpwm...
But to install something in SBCL is far easier than to rebuild Clisp :-D
start sbcl and enter:
(require 'asdf)
(require 'adsf-install)
(asdf-install:install 'clx)
That might take a while, but afterwards you should be ready.