[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Simulavr-devel] ATmega328 Emulation
From: |
David Madden |
Subject: |
Re: [Simulavr-devel] ATmega328 Emulation |
Date: |
Wed, 16 Feb 2011 20:25:06 -0800 |
User-agent: |
Mozilla/5.0 (X11; U; Linux x86_64; en-US; rv:1.9.2.4) Gecko/20100709 Lightning/1.0b2pre Lanikai/3.1 |
On 02/16/2011 08:14 PM, David Madden wrote:
Hi, I'm a new user, hoping to use Simulavr to figure out how to run
FreeRTOS on an ATmega328.
Uh oh, after more poking around, it's possible that it's a GDB
communications (or pure GDB) issue. Single-stepping goes to the
expected instruction addresses, and the registers change as expected.
It's just that x/i gives bad disassembly. That makes it Really Hard to
trace/debug, but it's better than nothing!
Any advice for fixing this? My GDB is brand-new too: 7.2, compiled
yesterday.
Thanks,
--
Mersenne Law LLC · www.mersenne.com · +1-503-679-1671
- Small Business, Startup and Intellectual Property Law -
1500 SW First Ave. · Suite 1170 · Portland, Oregon 97201