Re: [Qemu-ppc] qemu-system-ppc64 -M ppce500 always booting to qemu monitor console plus no output on serial console

[Do Vincenzo]

On 16.12.15  14:38, Alexander Graf wrote:
> Please don't top post on this mailing list :). Just write your replies
> below the previous ones at the place the original question was.

Ok got it, I'm just not that used to sending e-mails on these lists.

> Yes, the option is correct. So that's not the problem. One thing you
> could try is to pass the uImage into -kernel rather than the kernel.

So I've already tried to use the uImage but still no output. 

> If that doesn't help, we need to dive into some debugging :). Boot the
> VM with the -s -S parameters. Then on a different shell do
> $ gdb vmlinux -ex 'target remote localhost:1234'
> In the following gdb shell, type
> (gdb) c
> after a bit, Ctrl-C and checl where you are
> (gdb) bt
> Also try to print the log buffer:
> (gdb) x /200c __log_buf
> That should give some hints on what's going wrong.
> Alex

Here's the log buffer after the steps you described: 
http://paste.ubuntu.com/14050259/

Regards,

Vincenzo Do